Before applying your Lettering or Graphics thoroughly clean and dry the area first

Position the lettering or graphics in the desired place and secure temporarily with masking tape as shown opposite

Apply masking tape along the top edge of the lettering or graphics and the surface its being applied to thus creating a hinge

When dealing with large letters or long lengths of lettering cut in between each individual letter first as shown opposite

Lift up the vinyl on its hinge and completely remove the backing paper as shown opposite and put this to one side for later

Slowly and carefully allow your vinyl to come back down and make contact with the surface its being applied to

Using a squeegee with a firm pressure  start at the top centre, work downwards and outwards when applying the lettering to the surface

Start removing the application tape at one corner and slowly draw it back on itself at 180 degrees as shown opposite

To ensure the vinyl is firmly attached cover it with the backing paper, the shinny side facing the vinyl, and squeegee again.  Any air bubbles pop them with a pin and squeegee again.